The upgrade file path cannot contain Chinese. Please download the firmware from the official website to upgrade. Note: Failure of the firmware upgrade will cause permanent damage to the system. At that time, the miner friends can extract and download the upgrade device to improve the device's performance.
#Fminer troubleshooting update#
The miner official website will update the device firmware from time to time. Click Maintenance Management to enter the upgrade interface.
#Fminer troubleshooting software#
Go to the System Status page, where you can get the board temperature, system hardware, software version number, and more.ħ.
Then, enter the miner state to observe whether the miner is usually working.Ħ. Click on the setting to make the mining pool effective. After the configuration is completed, mining can be carried out. Similarly, the second group of mines will automatically switch to the third group. If the first group of mines is hung, it will automatically switch to the second group. The mining pool is divided into three groups, which can be filled into three groups. (The miner's name should correspond to the name of the miner in the mining pool). Mining Pool 1 information is configured with f2pool, stratum+tcp://:3333 is the mining pool, some networks will block 3333 ports, f2pool can be replaced with 8888 or 25, XXXX is the name, and the password can be filled in as needed. Click the miner and click on the miner settings to enter the miner configuration page. Be sure to click the Settings button after making changes.ĥ. If there are more than two wing bits, please modify the IP address to other addresses. Click the network management button to enter the network management information configuration page. After logging in to the miner, click on the device information - device status, you can see the device frequency, hash rate, temperature, and the system configuration is displayed on the page (intuitive reaction pool task no response times, power warning, temperature warning threshold, device shutdown temperature threshold, frequency setting, etc.).Ĥ. Next, enter the default user account of the miner admin, and the password is also admin by default, then click login to log in.ģ. After the route restart is complete, open your browser and enter the IP address on your mining fan.
Ensure that the settings take effect in real-time.Ģ. First, point the network neighbor to find the local connection, select the Internet protocol point properties, open the window settings, click OK and then OK, and finally right-click on the local connection point to repair. After the modification, restart the router and connect the wing bits with the network cable.Ģ) Set the IP of your computer's wired network card to 192.168.80.199, subnet mask 255.255.255.0, and leave the gateway blank. So if it is 192.168.80.1, there is no need to modify it. The miner and the computer IP are not in the same network segment and need to be set.ġ) Open your router configuration, set the router's LAN port to 192.168.80.1, the general router defaults to 192.168.1.1 or 192.168.0.1. The hardware connection can not be opened normally. The latest batch of EBIT miner default addresses is 192.168.80.140. And please be patient and read the following steps.ġ. You can easily set up the miner by following the steps below. The web interface setting of the Ebit E9 miner is friendly and straightforward.
0 kommentar(er)
